Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 30)

W A S H S E L E C T I I
Document Number: WS21058 18
Document Title: WSII Operations Manual ver 6.10
Note:
This feature may require hardware changes. If after it has been enabled, you find it
does not work, refer to the Wash Select II Installations Manual for wiring instructions.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) OOS Timer (*)
2. You will be prompted to enter the Delay before OOS. This may be set anywhere
between 1 – 300 seconds (5 minutes).
Default: 60 seconds
2.5.8 Tunnel Wash Settings
The WSII can be installed at tunnel washes with or without barrier gates and with or without
live attendants. Each detail of your wash can be set using the Tunnel Mode, Barrier Gate,
and Receipt Bar Code configurations in the Wash Interface menu.
2 . 5 . 8 . 1 T u n n e l M o d e
When the Tunnel Mode is set to “Attended,” each customer will receive a receipt to give to
the attendant, who will then arm the appropriate wash. When the Tunnel Mode is set to
“Unattended,” customers will not automatically receive a receipt.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) Tunnel Mode (*)
2. Press the (1) button for “Unattended Tunnel Mode” or the (2) button for “Attended
Tunnel Mode” or (0) button to disable tunnel mode (rollover washes only), and
then press the (*) key.
2 . 5 . 8 . 2 B a r r i e r G a t e
You must have a Barrier Gate Interface Box in order to use the Barrier Gate feature.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) Barrier Gate (*)
2. Press the (3) button to disable the Barrier Gate option, or the (1) button to enable
the option.
2.5.9 Combo Mode
Combo mode is used when your car wash is equipped to wash vehicles using both the
“friction” and “touchfree” methods (the names are configurable; see the next section), and
you want to give your customers the ability to select between the two depending on the wash
bought. For instance, the purchase of your most expensive wash type treats customers to
both wash methods (i.e. a combo), while the lesser wash types give a choice between friction
and touch free. A selectable wash works by sending a different relay pattern to the wash
depending on the wash method selected. Follow the steps below to set the combo mode
option for each wash type. After setting the combo mode, you will want to also check and
perhaps reconfigure the relay patterns for each wash. See the Combo Mode Addendum
(Unitec Document WS21020) for further information.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) Combo Mode (*)