Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 61)

W A S H S E L E C T I I
Document Number: WS21058 49
4 . 3 . 1 . 2 R e p l a c i n g t h e S t a c k e r
To replace the stacker, perform the following steps:
1. Position the stacker behind the Mars Bill Validator with the hinged doors on the
side, and the back of the stacker facing away from you.
1. Place the stacker against the bill validator.
2. Align the tabs on the bill stacker just above the guide slots on the bill validator.
3. Slide the stacker tabs into the guide slots, and then down until it is fully seated, as
shown in Figure 8.
Figure 8. Mars Bill Stacker Replacement
4 . 3 . 1 . 3 M a r s B i l l V a l i d a t o r F l a s h C o d e s
The Mars Bill Validator is equipped with an internal diagnostic LED flash code system. This
LED flash code system is used to alert the operator of a failure or to indicate a need for
servicing.
The flash code LED is located in the lower section of the validator, below the stacker. See
Figure 9 for the LED location.
Document Title: WSII Operations Manual ver 6.10