Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 115)

W A S H S E L E C T I I
Document Number: WS21058 103
Document Title: WSII Operations Manual ver 6.10
“processor type” to zero and disabling Autobatch. In addition, do the procedures
found under “If you want to do batch opening/closing manually” above.
F. CashCode Bill Validator
The Canadian Wash Select II comes equipped with the CashCode bill validator.
1. Emptying the Bill Stacker
The CashCode bill stacker will hold up to 400 bills and is equipped with a keyed-entry vault.
To empty the bill stacker, squeeze the release levers located on both sides of the bill stacker
while pulling it back. Lift the bill stacker up and back to remove it from the bill validator. You
will need a key (included with the CashCode bill validator) to open the stacker and remove
the bills.
2. Replacing the Stacker
To replace the bill stacker, slide the base of the stacker into the mount guides. Press the
sacker forward until it snaps into place.
3. Flash Codes *
The diagnostic LED on the CashCode bill validator is located on the front of the unit. If it is lit,
it indicates there is a problem. If the red light on the front of the bill validator is ON insert bill
and remove it after the red light goes OFF. Count the number of flashes and compare with
the diagnostic chart below.
Table 21. CashCode Bill Validator Diagnostic Flash Codes
# Description # Description
1 Cassette is removed
from bill validator
7 Failure of magnetic
sensors
2 Stacking motor does
not rotate 8 Transport motor does
not move
3 Cassette is full 9 Speed of transport
motor is too high
4 Mechanical jam in
the cassette
10 Transport motor
electrical overload
5 Stacking motor
electrical overload
11 Bill pathway security
latch is open
*
Taken from the CashCode® Model AMZ-USA-MDB-UNV User’s Guide