Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 51)

W A S H S E L E C T I I
Document Number: WS21058 39
Document Title: WSII Operations Manual ver 6.10
Upon completion of the withdrawal, the WSII printer will issue a receipt listing the amounts
added and updated cash balances. The transaction is also recorded in the WashPay server.
3.4 Diagnostics Menu
The Diagnostics menu contains diagnostics functions that are used for troubleshooting and
testing the Wash Select II system components.
3.4.1 Testing Output Relays
In this sub-menu, you may turn each of the Wash Select II outputs on or off. To test the
output relays:
1. Place the WSII in Setup mode. Scroll to: Diagnostics (*) Test Outputs (*)
2. Once you are in the “Test Outputs” menu you may turn the following outputs on
or off, by pressing (1) for YES or (3) for NO. (You may scroll to the next option
using the (3) key.)
• Wash Relay 1 – output to car wash controller
• Wash Relay 2 – output to car wash controller
• Wash Relay 3 – output to car wash controller
• Wash Relay 4 – output to car wash controller
• Wash Relay 5 – output to car wash controller
• Wash Relay 6 – output to car wash controller
• Wash Relay 7 – output to car wash controller
• Wash Relay 8 – output to car wash controller
• Bill Enable – Signal to bill validator (not bill validator power)
• Coins Enable – power to coin acceptor
• Fault Relay – output to external device such as car wash controller
• Warning Relay – output to external device such as car wash controller
• Auxiliary 1 – spare output on display I/O board for external fleet card
• Auxiliary 2 – spare output on display I/O board for external fleet card
• Auxiliary 3 – spare output on display I/O board for external fleet card
• Auxiliary 4 – spare output on display I/O board for external fleet card
• RFID Light – Toggle Speedpass light on and off
• AWID Power – Toggle power to ReachFree ID reader on and off
3.4.2 Cycling Output Relays
This function will cycle through all Wash Select II outputs. For a list of the outputs, see the section
above. Follow the steps below to cycle output relays: