Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 47)

W A S H S E L E C T I I
Document Number: WS21058 35
Document Title: WSII Operations Manual ver 6.10
3 4
4 5
To set the bay address, follow the steps below.
1. Place the WSII in Setup mode. Scroll to: POS4000 Link (*) Set Bay Address (*)
2. Enter the “Bay Address” of the unit you are configuring, and then press the (*)
key.
2 . 1 3 . 3 . 2 S e t M u l t i - U n i t F l e e t B a y A d d r e s s
The Wash Select II multi-unit function is not applicable when interfacing with the
WashPay server. The WashPay server tracks activity on all units.
2.13.4 Convey Accounting
This feature allows the POS4000 to receive information when cash or other forms of payment
are used at the Wash Select II coin box. If you choose to not have accounting information
conveyed (you may do this in the case of revenue sharing if codes are being sold by a
partnering merchant), all coin-box accounting information is withheld from the POS4000.
Follow the steps below to enable/disable the “Convey Accounting” feature.
Table 6. Conveying Accounting
Use Setting
Carwash and store where POS4000 is
located are owned by the same person(s) Yes: Enabled (default)
Carwash and store where POS4000 is
located are owned by 2 separate persons
(revenue share) No: Disabled
1. Place the WSII in Setup mode. Scroll to: POS4000 Link (*) Convey Accounting
(*)
2. Press the (1) key for “YES” (enabled) or the (3) key for “NO” (disabled).