Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 79)

W A S H S E L E C T I I
Document Number: WS21058 67
Document Title: WSII Operations Manual ver 6.10
1. A speech module circuit board, which plugs into the CPU board.
2. A speaker, which is attached to the door.
3. A speaker grille, which is attached to the outside of the door.
4. A speaker cable, which runs from the CPU board to the speaker.
5. A microphone, which plugs into the top of the speech board and is used to record
voice messages.
4.6.1 Recording Messages
Before you begin recording your personal speech messages, it is suggested that you study
the “Speech Message Script” below. It shows the time allotted for each message and gives
the pre-recorded messages already programmed on your unit.
S P E E C H M E S S A G E S C R I P T
1) GREETING MESSAGE (10.25 seconds)
Hello, welcome to _______________ car wash. Please Select your wash or enter
your code now.
2) SELECT PACKAGE (4.25 seconds)
Please select your wash package now.
3) PACKAGE 1-PURCHASED (8.5 seconds)
You have purchased the _______________. You may enter the wash if it is ready.
4) PACKAGE 2 PURCHASED (8.5 seconds)
You have purchased the _______________. You may enter the wash if it is ready.
5) PACKAGE 3 PURCHASED (8.5 seconds)
You have purchased the _______________. You may enter the wash if it is ready.
6) PACKAGE 4 PURCHASED (8.5 seconds)
You have purchased the ________________. You may enter the wash if it is ready.
7) CODE INVALID (4.25 seconds)
Your code is invalid. Please try again.
8) RECEIPT PROMPT (4.25 seconds)
Would you like to have a receipt?
9) AUTHORIZING (5.75 seconds)
Please wait while your card is being authorized.
10) CARD FAILURE (5.75 seconds)
Your transaction was not authorized. Please try again or use another payment
method.
11) HOPPER FAILURE (8.00 seconds)
Your change was not completely dispensed.
12) WASH IS READY (8.00 seconds)