Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 83)

W A S H S E L E C T I I
Document Number: WS21058 71
Document Title: WSII Operations Manual ver 6.10
Table 15. System Settings Affecting Proximity Sensor Operations
Setting Effect
Greeting Delay This defines how long the Wash Select II should
wait to play the greeting message for the first time
after a customer has driven up.
Repeat Delay This defines how long the Wash Select II should
wait to play the greeting message again if
customer activity has yet to begin. The greeting
message will stop repeating once the customer
initiates an action with the unit, such as adding
money, selecting a wash or swiping a credit card.
4.8 Coin Hopper and Assembly
The Wash Select II is equipped with a Suzo Mark II coin dispenser, which is embedded in a
proprietary Unitec design. The dispenser is able to hold/dispense up to 2,400 quarter-sized
coins. It is located inside the Wash Select II case directly behind the wash selection displays.
4.8.1 Filling the Hopper
The large opening at the top of the coin hopper has been added to increase the holding
capacity of the dispenser. The inclined plane that spans across the top half of the hopper
assembly is used to distribute the weight of the coins. When pouring coins into the dispenser,
you must direct the coins at this inclined plane to protect the moving parts at the bottom of the
hopper. Follow the instructions below to fill the coin hopper.
1. Open the door to the Wash Select II.
2. Pour the replacement coins into the large opening at the top of the hopper
assembly. Remember to direct the coins toward the inclined plane.
3. When the coin level is close to 600 - 1200 coins, begin to add coins by hand.
Using this method, coins will tend to slide into the dispensing wheel more easily,
which will reduce to possibility of clogs and jams.
Time and experience should be your guide as to when to refill your hopper. Unitec
recommends starting with approximately 900 coins to maintain a good accept/dispense ratio.
4.8.2 Removing the Hopper from the Wash Select II
To remove your hopper, follow the steps below.
1. Grasp the handle, located across the top of the hopper and pull the hopper up
and out. Be careful not to accidentally jerk the wires out of the back of the hopper.
2. Once the wires at the back of the hopper are visible, grasp them at the brown
plug housing and pull them straight back.
3. Gently rock the connector back and forth while pulling them outward until they
have been disconnected from the hopper.