Banner PresencePLUS BCR 1.3 Series - Manual (Page 152)

Character Connectivity Calibration
Intra-Character Connectivity defines the maximum number of pixel spaces between two character strokes so
that both strokes will be considered part of the same character. In the example below, if the Horizontal Gap
were defined too small, the "H" could be considered an I - I.
Note: Here "0" vertical gap really means "infinite" vertical gap (but bounded by the ROI); that
is, all pixels in a vertical line can be considered part of the same character.
Parameters
The following are the parameters that you adjust to set Intra-Character Connectivty.
Additional Information Description Intra-Character Connectivity
Use the up or down arrow
controls to set the maximum Max Horizontal Gap
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
152
7/2009 PresencePLUS Software Tools