Metrohm VESUV - Manual (Page 88)

Vesuv 3.0 6. Database
• 83
Note : If you rename the axis label then the name
of the quantity shown will also be renamed.
1st Y value Quantity to be shown on the vertical axis (=Y
axis).
Renaming the quantity: see under "X axis".
2nd Y value 2nd quantity to be shown on the same X axis,
i.e. 2 superimposed curves will be shown.
With "None" only 1 curve will be shown.
Renaming the quantity: see under "X axis".
Main title Title which will be shown in the 1st line. The title
only applies to the currently selected curve.
Subtitle Title which will be shown in the 2nd line. The ti-
tle only applies to the currently selected curve.
If curves are overlaid the 2nd title appears as
the legend.
Show legend Displays the legend in which the curve colors
are assigned to the quantities shown.
Show subtitle Displays the subtitles.
Show measuring points Measuring points are marked on
the curve. This is only possible when curve
smoothing is switched off.
Smoothing Switches on curve smoothing. This can be ad-
vantageous for curve evaluation, etc.
Show original too Displays the unsmoothed original curve.
In this way you can see how well the smoothing
process reproduces your curve.
X, Y Smoothing factors.
Higher value means more smoothing.
X: Smoothing for X axis.
Y: Smoothing for Y axis
The smoothing factors may help for parallel
evaluations. If you find too many endpoints you
should smooth more. The smoothing factor of
the volume axis should remain small (0.01). For
the measuring axis, you may try to increase
smoothing from 0.01 to 0.1, 1, 10, 100, 1000.
If the original curve differs too much from the
smoothed curve, you should decrease smooth-
ing.