Metrohm IC Net 2.0 - Manual (Page 60)

5 Interfaces
IC Net 2.0 52
5.6.2 Timer program
The Timer window contains the user-defined program for sys-
tem tasks. These tasks are started automatically at the day and
time defined in the program.
The title line of the
Timer
window shows the current time left in
days:hours:minutes:seconds until the next task is automatically
started.
Add a new task to the timer program.
Selecting this option opens a subwindow for
selection of the days at which the task should
be started.
Selecting this option opens a subwindow for
selection of time and day at which the task
should be started. After the selection of the
desired program instruction the system file for
which this instruction should be applied must
be selected in the
Systems
folder.
Add a new subtask for the selected daily task.
The time and program instruction for this
subtask has to be entered in the opened sub-
window and the system file to which this in-
struction should be applied must be selected
in the Systems folder.
Delete the selected task from the timer pro-
gram.
The following program instructions can be used for user-
defined event program tasks in the
Timer program
window:
Open
Open the selected system.
Close
Close the selected system and disconnect it
from the workplace.
Startup Startup hardware
of the selected system.
Start Start determination using the selected system.
Stop Stop determination using the selected system.
Shutdown Shutdown hardware of the selected system.