Rockwell Automation Migrating PanelView Enhanced Terminal Applications - Manual (Page 32)

32 Publication 2711P-QS001A-EN-P - October 2007
Chapter 4 Review the Application Conversion Log
converted
to memory tag, as its data type is not
supported. Any PanelView ’e’ Remote I/O tags with these data types are
converted to HMI memory tags.
•
1 Digit BCD
•
2 Digit BCD
•
3 Digit BCD
•
5 Digit BCD
•
6 Digit BCD
•
7 Digit BCD
converted
to memory tag, as the "Bit Position"
data type is not supported. If the data type of a PanelView ’e’ Remote I/O tag is bit
position but the address does not reference a single bit, the
tag is converted to an HMI memory tag.
converted
to memory tag, as its addresses
references an undefined rack. If a PanelView ’e’ Remote I/O tag has an address with an
undefined rack, the tag is converted to an HMI memory tag.
converted
to memory tag, as its addresses is
invalid. If a PanelView ’e’ Remote I/O tag does not have a valid I/O
address or block transfer address, the tag is converted to an
HMI memory tag.
Conversion Log Messages
Message Applies to this
PanelBuilder 1400e object Description