Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 95)

Chapter 6
The Transfer Menu
6 – 7
You can upload one file at a time from a DL40 to the Offline Programming
Software. When you select
Upload from DL40 (RS-232/RS-485) , the
Upload File from DL40 window will appear. Move the cursor to DL40 Port
and press [
↵
]. Select RS-232 or RS-485 from the pop-up window and
press [
↵
] . A message will flash briefly to indicate that the Offline
Programming Software is saving the setup file.
Figure 6.5
Upload File from DL40 screen (via RS-232)
To configure your computer’s communication port, select Configure Port on
the Upload to DL40 menu, then press [
↵
] . Select COM1 or COM2 , press
[
↵
] , specify your computer’s address (if using RS-485), and select a baud
rate in the Configure Port pop-up window.
Note: To change parity or data bits, return to the Develop → Ports menu.
If necessary, you can select Directory to change the currently selected data
directory for the uploaded files.
Uploading a File
Via RS-232 or RS-485