Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 33)

Chapter 3
Installing the Software
3 – 7
9 If you are using a card other than the 1770-KF2, the contents of the
CFG_KT.INI file should be similar to the format shown in the sample file
below. This sample is for a 1784-KT board:
[DTL_KT.Options] ①
PATH=C:\ABIC\BIN ②
③
[DTL_KT.1] ④
DEVICE=KT ⑤
MEMORY=C800 ⑥
PROTOCOL=DHPLUS ⑦
IRQ=5 ⑧
STATION=77 ⑨
NAME=DTL_KT 1 ⑩
In this file:
① This line identifies the file and prefaces a section of the file used to record
information common to all the communications interface cards on your
system.
② PATH line that designates the directory where the INTERCHANGE
server programs are located. This will be the same value for all interface
cards on your system.
③ Blank line to separate sections and improve readability.
④ This line identifies the general class of hardware device (in this case a KT
device) and a logical pushwheel identifier of 1. Note: The DL40 Offline
Programming Software assumes that pushwheel 1 is used. Use only
pushwheel 1 when communicating with the DL40 Offline Programming
Software.
⑤ DEVICE line that specifies the exact communication interface card used.
Acceptable values include KT, KTX, KL, KT2, or PCMK.
⑥ MEMORY line that matches the dip switch settings on the interface card.
⑦ PROTOCOL line that identifies the protocol in use.
⑧ IRQ line that matches the dip switch settings on the interface card.
⑨ STATION line designates the octal station address on the local
communications link.
⑩ NAME is a unique string you define to specify to this configuration.