Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 82)

Chapter 5
The Develop Menu
5 – 37
Parameter Available choices
Null Count 0 to 255
Width 20 to 132
RS-232 Tape Recorder Settings
Note that RS-232 Tape Recorder Settings are valid only when writing to
or reading from a tape drive, and that communications to a tape recorder can
be made only via the RS-232 port.
Baud rate is the only modifiable parameter applicable while using a tape
recorder. Your choices are listed below. The default value appears in bold.
Parameter Available choices
Baud Rate 300, 1200, 2400, 4800, 9600
This setting will revert to normal RS-232 Port settings (described above)
when the Tape function is finished.
Triggering Port Settings
The parameters presented here will differ between Remote I/O and Parallel
Port versions of the DL40 Message Display. The following settings are
available from this menu item on Remote I/O units. The default value
appears in bold.
Parameter Available choices
Message Format Binary, BCD
Variable Format Binary, BCD
Control-W Format BCD, ASCII
Bit Trigger Priority Section
Size
0 to 31 words
Always Send Clock Data Yes or No
➀
➀ If selection is Yes, only clock data will be returned to a PLC no matter what attributes
are set or what data is requested.
The following settings are available from this menu item on Parallel Port
units. The default value appears in bold.