Rockwell Automation 2706-ND1 DL40 OFFLINE PROGRAMMING SFTWR.USER MANUAL - Manual (Page 104)

Chapter 6
The Transfer Menu
6 – 16
If you choose ETHERNET , you must then specify an IP Address in the
appropriate field. IP Addresses take the following form:
X.X.X.X
where X is a decimal number from 0 through 255. Consult your network
administrator to obtain an IP Address.
Setting Device Parameters for a DH+ Network
Additional transfer parameters may be necessary when you select DH+
communications devices. For card numbers 1784-KT, 1784-KT2, 1784-KL,
1784-KTX, and 1784-PCMK devices, you must specify the
DH+
Connection Type and DH+ Network Access .
Figure 6.12
1784-KT, KTX, PCMK configuration screen for DH+ network
Parameter Acceptable values
DH+ Connection Type Direct
Multidrop
DH+ Network Access Local
Remote (Bridge)
DH+ Connection Type
Select Direct if your programming computer and your PLC-5 are the only
devices on the DH+ link, or if there are multiple devices on the link and your
programming computer is the first or the last physical device on the link.
Select Multidrop if there are multiple devices on the link and your
programming computer is not first or last physical device on the link.