Rockwell Automation 1756-HIST2G Historian ME 2.1 - Manual (Page 122)

F ACTORY T ALK H ISTORIAN ME M ODULE U SER ’ S G UIDE
112
Configuring Data Transfer
To configure the Data Transfer service, click Configure Historian in the top
navigation bar, and then click Data Transfer in the left navigation bar.
Prerequisite Information
Before transferring data, you must:

Ensure that you have administrator privileges and other necessary security
settings configured to enable the Data Transfer service in the FactoryTalk
Historian ME.

Ensure that your system has time synchronization setup and configured for the
FactoryTalk Historian ME, controllers, the FactoryTalk Historian SE server and
clients.

Ensure that the proper licenses (using FactoryTalk Activation) are installed and
configured (through the FactoryTalk Administration Console) on the FactoryTalk
Historian SE.

Ensure that trust connections between the FactoryTalk Historian ME and the
FactoryTalk Historian SE are set up and configured properly before you begin
transferring data.
See the “Managing Security” chapter for security administration information.
See the “Managing Time” section for more information about trust configuration.
See the “Installing FactoryTalk View SE Patch” section for more information about
installing the FactoryTalk Historian SE patch necessary to transfer data from the
FactoryTalk Historian ME.
See the “Managing Security Trusts” section for more information about trust
configuration.