Lenze ECSCSxxx - Manual (Page 134)

Commissioning
Selecting the operating mode/control structure
Torque control with setpoint via analog input
6
l
134 EDBCSXS064 EN 4.0
6.10.4 Torque control with setpoint via analog input
Configuration C3005 = 4000
)
Note!
Use the "input assistant for motor data" of the GDC for setting the motor data
(
^ 100).
Set the following codes:
Code Meaning Further
information
DC−bus voltage thresholds and charge relay function
C0173 = x DC−bus voltage thresholds ^ 99
C0175 = x Charge relay function
(when using an ECS supply module: C0175 = 3) ^ 98
Maximum motor current
C0022 = x [A] Maximum motor current (I
max
)
Controller configuration and feedback system
C3005 = 4000 Torque control with setpoint via analog input ^ 126
C0495 = x Feedback system ^ 103
Speed setpoint settings
C0011 = x [rpm] Maximum speed ^ 355
C0012 = x [s] Acceleration time ^ 351
C0013 = x [s] Deceleration time
C0105 = x [s] Quick stop deceleration time ^ 358
Speed limitation
C0472/4 = x [%] Speed limit (positive value) ^ 349
C7131/1 = 52 FCODE C0472/4
C7531/2 = 651 InNeg−AnOut1
C7531/5 = 52 FCODE C0472/4
Application parameters
C0070 = x Proportional gain (V
p
) of speed controller ^ 355
C0071 = x [ms] Integral−action time (T
n
) of speed controller
Save parameters
C0003 = 1 Save all parameters