Lenze EVS93xx FlyingSaw - Manual (Page 99)

FlyingSaw
Description of the function blocks
Prepared Solution Servo PLC / ECSxA 1.1 EN 10-1
10 Description of the function blocks
10.1 Function block MotionControl
In the FlyingSaw application the function block MotionControl undertakes the positioning tasks
and the referencing.
During synchronisation to the material speed the setpoints are fed through and switched to the
interface MCTRL.
The function block MotionControl represents the interface between application and drive control
(MCTRL).
Task information
Can be called in: Cyclic task Time-controlled task
(INTERVAL)
Event-controlled task
(EVENT)
Interrupt task