Lenze EVS93xx FlyingSaw - Manual (Page 69)

FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN page 4-56
Open the parameters for the configuration of the measuring wheel (FlyingSaw_SPLS_V0100 Î settings flying saw):
Set the following codes:
C3003/000 = gear numerator of the measuring wheel
C3004/000 = gear denominator of the measuring wheel
C3005/000 = Circumference of the measuring wheel in [units]
C3006/000 = Encoder pulses from the measuring wheel
The normalisation factor is determined automatically and displayed in the codes C3003
(numerator normalisation factor) and code C3004 (denominator normalisation factor).
TIP!
The calculation of the normalisation factor is explained in chapter 9.
Step 5