Lenze EVS93xx FlyingSaw - Manual (Page 26)

FlyingSaw
Features of the Prepared Solution
Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-13
2.9 Applicability criteria for the parameterisable Prepared Solution
In order to be able to check and estimate the suitability of the Prepared Solution with regard to
your application case, the following decision criteria and boundary conditions within which the
Prepared Solution can be used are provided
Are the possible combinations adequate for your specific application?
Depending on the specific application, different combinations for the use of the flying saw
can be considered
1. Synchronous synchronisation, during this process the master value is measured by
a measuring wheel. The lengths are calculated by the internal length calculator.
2. Oversynchronous synchronisation, during this process the master value is
measured by a measuring wheel. The lengths are calculated by the internal length
calculator.
?
NO
YES
Your specific application
cannot be solved currently
using the Prepared
Solution, as it only permits a
mark control in
oversynchronous mode