Lenze EVS93xx FlyingSaw - Manual (Page 75)

FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN page 4-62
Check the correct feedback of the application status word (word 3 and word 4) from the servo controller for the
flying saw axis to the higher-level PLC. For this purpose you can display the actual application status word from
code C4150/000 and compare it with the value received in the PLC:
Enable the servo controller by connecting terminal 28 to 24V. Test the positive manual control functions by
setting the corresponding control bit in the application control word (positive manual control: bit 2).
If the drive does not move from the initial position in the direction of the cutting position during positive manual
control, change code C3000/000 (motor mounting direction) so that the required position polarity is achieved.
Step 5
Step 4