Lenze EVS93xx FlyingSaw - Manual (Page 79)

FlyingSaw
Commissioning length-controlled operation
Prepared Solution Servo PLC / ECSxA 1.1 EN page 5-1
5 Commissioning length-controlled operation
Attention!
The commissioning of the length-controlled operation of the Prepared Solution described in the
following relates to the parameterisable variant.
Requirements:
ƒ
The parameters for the servo controller for the flying saw axis have been specifically set to suit the specific
case, as described in chapter 4.4.3.
ƒ The axis is supplied with control voltage using terminals 59 (+24V DC) and 39 (0V) and with power using
terminals L1, L2 and L3.
Initial situation:
• The servo axis is not indicating any error.
• The servo axis is enabled.
• Application control word and application status word have not been specifically set using C4010/0xx and
C4012/0xx.
• The axis has been successfully homed.
Start GDC and perform a search for drive controllers connected to the system bus. GDC finds the drive
controllers connected. These include the drive controller loaded with the FlyingSaw_SPLSC_V0100 project.
Application with ECSxA
Application with ServoPLC
Double-click the controller to be loaded with the FlyingSaw_SPLC_V0100 application.
Now set the specific parameters of your flying saw application
Start
Step 1
Step 2