Lenze EVS93xx FlyingSaw - Manual (Page 52)

FlyingSaw
Functions
Prepared Solution Servo PLC / ECSxA 1.1 EN page 3-39
Status interface
Meaning
Bit 00: Dependent on the setting in code C4000/000
Bit 01: Dependent on the setting in code C4000/000
Bit 02: Dependent on the setting in code C4000/000
Bit 03: Dependent on the setting in code C4000/000
Bit 04: Dependent on the setting in code C4000/000
Bit 05: Dependent on the setting in code C4000/000
Bit 06: Dependent on the setting in code C4000/000
Bit 07: Dependent on the setting in code C4000/000
Bit 08: Dependent on the setting in code C4000/000
Bit 09: Dependent on the setting in code C4000/000
Bit 10: Dependent on the setting in code C4000/000
Bit 11: Dependent on the setting in code C4000/000
Bit 12: Dependent on the setting in code C4000/000
Bit 13: Dependent on the setting in code C4000/000
Bit 14: Dependent on the setting in code C4000/000
Bit 15: Dependent on the setting in code C4000/000
System status
word
Wo
rd
0
(not used)
Data word 1
Wo
rd
1
Bit 00: Program initialisation
Bit 01: Homing done
Bit 02: Synchronised signal
Bit 03: Gap made
Bit 04: STATUS standby
Bit 05: STATUS homing active
Bit 06: STATUS inching in positive direction active
Bit 07: STATUS inching in negative direction active
Bit 08: STATUS top cut active
Bit 09: STATUS automatic selected
Bit 10: STATUS top cut in the ongoing process
Bit 11: STATUS length cut active
Bit 12: STATUS mark cut active
Bit 13: STATUS error active, global error message
Bit 14: Normalisation factor calculated
Bit 15: Homing active
Wo
rd
2
Bit 16: Positioning active
Bit 17: Double length (only length-controlled operation)
Bit 18: Initial position reached
Bit 19: Mark not detected (only mark-controlled operation)
Bit 20: Error detected
Bit 21: Warning
Bit 22: Message
Bit 23: Fail-QSP
Bit 24: (not used)
Bit 25: DCTRL ready
Bit 26: Axis has controller inhibit
Bit 27: Axis is in QSP
Bit 28: (not used)
Bit 29: (not used)
Bit 30: (not used)
Bit 31: (not used)
Applicat
ion st
at
us word
Wo
rd
3