Lenze EVS93xx FlyingSaw - Manual (Page 66)

FlyingSaw
Commissioning the "(Flying Saw)"
Prepared Solution Servo PLC / ECSxA 1.1 EN page 4-53
4.3.2 Sequence for online commissioning using GDC
Start GDC and run a scan on the system bus for drive controllers connected. GDC finds the
drive controllers connected. These include the drive controller that is loaded with the
FlyingSaw_SPLC_Vxxxxxx project or with the FlyingSaw_ECS_Vxxxxxx project.
Application with ECSxA
Application with ServoPLC
Double-click the drive for the flying saw axis and read the parameters back from the drive.
Start the motor data wizard:
Follow the instructions in the motor data wizard to correctly set the motor connected.
Once you have finished setting the parameters for the motor, close the motor data wizard.
Start
Step 2
Step 1
Start the motor data wizard
by clicking the icon with the
motor equivalent circuit.