Lenze EVS93xx FlyingSaw - Manual (Page 132)

FlyingSaw
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 11-10
Possible settings:
C4135 0 0 ... ...
4294967295 {1} Control code:
Using the control code the flying saw can be controlled
(with C4000/000 = 0). The individual bits of the control
code can be defined as required using the configuration
codes C4010/001 … 0032. The factory-set bit assignment
is given in code C4010/xxx.
C4136 - 0 ... ...
4294967295 {1} Indication of the actual application control word:
Dependent on C4000/000 the actual application control
word is displayed here. The meaning of the individual bits
of the application control word can be defined as required
using the configuration codes C4010/001 … 0032. The
factory-set bit assignment is given in code C4010/xxx.
C4150 0 0 ... ...
4294967295 {1} Status code (display code):
Using the status code the complete application can be
monitored (with C4000/000 = 0). The individual bits of the
status code can be defined as required using the
configuration codes C4012/001 … 0032. The factory-set bit
assignment is given in code C4012/xxx.
C4500 - 0… 32767 {1] Cut counter indication:
All pieces completely processed are counted here. The cut
counter is decremented when the scrap counter has been
triggered
C4501 - 0… 32767 {1} Scrap counter indication:
All pieces cut out of the material with an immediate cut are
counted here.
C4502 - 0… 32767 {1} Top cut counter:
The number of top cuts is counted here.
C5000 - -2147480000…
2147480000 {0.0001[units]} Indication of the actual position of the axis