Lenze EVS93xx FlyingSaw - Manual (Page 126)

FlyingSaw
Appendix
Prepared Solution Servo PLC / ECSxA 1.1 EN 11-4
11.2.4 VarInterfaceFlyingSaw
Global variables (Variable type: VAR_GLOBAL)
Identifier Data type Value/meaning
g_bDriveReady BOOL Drive ready signal
g_bStartHoming BOOL Start homing
g_bHomingMark BOOL Homing cam
g_bManualJogPos BOOL Inching in positive direction
g_bManualJogNeg BOOL Inching in negative direction
g_bStartPositioningHome BOOL Move to initial position
g_bAutomatic BOOL Start automatic operation
g_bCutReady BOOL Cut done signal
g_bHeadCut BOOL Trigger top cut
g_bStartGap BOOL Make gap in the material
g_bTPUnrealised BOOL Mark not detected during mark control
g_bMarkenSync BOOL Activate mark synchronisation
g_bModusSynchronize BOOL Synchronisation mode
g_bTripReset BOOL Reset error
g_bTripresetMultiPlex BOOL Reset error using multiplexer
g_bUserTripSet BOOL Set user error
g_bImperialUnits BOOL Switch between imperial and metric measuring system
g_nSimulationFrequency INT Simulation speed
g_bSelInputFrequency BOOL Switch between DFIN and simulation
g_dnFollowErrorLimt DINT Following error limit
g_bHomePositionAvailable BOOL Home position known
g_bGapStatus BOOL Gap made in the material
g_bAxisSynchron BOOL Axis synchronised signal
g_wActualFaultNumber WORD Actual error number
g_bHomingBusy BOOL Homing is active
g_bPosBusy BOOL Positioning is active
g_bDoubleLength BOOL Double length detected
g_dnActPosFlyingSaw DINT Actual position of the axis
g_byCtrlMode BYTE Multiplexer mode
g_nFiltering INT Master speed filtering
g_dwTiFlyingSaw DWORD Flying saw acceleration time
g_dwTifFlyingSaw DWORD Flying saw deceleration time
g_dnOffsetTP DINT Distance between mark detection and the initial position
g_bSoftwareLimitsActive BOOL Software limit switches active
g_bCutCounterUP_NOK_Multi BOOL Operate scrap counter via the multiplexer