Lenze EVS93xx FlyingSaw - Manual (Page 35)

FlyingSaw
Features of the Prepared Solution
Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-22
2.16 Manual control
The Prepared Solution makes it possible to move the axis manually by hand. During this
process a differentiation is made between positive and negative inching mode. The parameters
that can be set for manual control apply to both traversing directions.
Activated software limit positions are monitored in the manual control mode and trigger an error
in the case of overtravel.
Possible settings: Code
Default Selection
Comments
C3100 500.0000 -214000.0000... {0.0001
[units/s]}
... 214000.0000 Velocity for manual operation (inching)
The selection relates to the entry for the machine
parameter
C3101 750.0000 -214000.0000... {0.0001
[units/s^2]}
... 214000.0000 Entry for the acceleration
The selection relates to the entry for the machine
parameter
C3102 750.0000 -214000.0000 {0.0001
[units/s^2]}
... 214000.0000 Entry for the deceleration
The selection relates to the entry for the machine
parameter