Lenze EVS93xx FlyingSaw - Manual (Page 39)

FlyingSaw
Features of the Prepared Solution
Prepared Solution Servo PLC / ECSxA 1.1 EN page 2-26
2.18 Delay on the synchronised signal
After synchronisation the flying saw is synchronised by speed and angle with the master value.
However, on reaching the master speed a settling process takes place that must be taken into
account for the synchronised signal. For this reason it is possible to set a delay using the code
C3009/000. The optimal setting is achieved if a synchronising process is recorded using GDO.
In the example below the effects of C3009/000 can clearly be seen:
t
V
sync speed
t
Verzögerung des
Synchron-Signals
in [ms]
t
V
line speed
Ausgang
„Synchron-Signal“
synchronous-
signal
delay of synhronous-
signal in [ms]