Lenze EVS93xx FlyingSaw Instruction Manuals and User Guides
We have 1 Instruction Manual and User Guide for EVS93xx FlyingSaw Lenze
Manuals 
| Recognized languages: | English |
|---|---|
| Pages: | 142 |
| Size: | 3.77 MB |
Show table of contents
Document Outline
- Manual Prepared Solution FlyingSaw
- Contents
- 1 Preface and general information
- 2 Features of the Prepared Solution
- 2.1 Definition of a flying saw
- 2.2 Example layout and functional principle
- 2.3 Typical applications
- 2.4 Synchronous synchronisation
- 2.5 Oversynchronous synchronisation
- 2.6 Length-controlled operation
- 2.7 Mark-controlled operation
- 2.8 "Start gap" function
- 2.9 Applicability criteria for the parameterisable Prepared Solution
- 2.10 Functions of the control inputs and outputs
- 2.11 Manual control
- 2.12 Start gap
- 2.13 Cut done
- 2.14 Immediate cut / top cut
- 2.15 Homing
- 2.16 Manual control
- 2.17 Moving clear from a limit switch
- 2.18 Delay on the synchronised signal
- 2.19 Status signal "Double length"
- 2.20 Status signal "Mark not detected"
- 2.21 Following error monitoring
- 3 Functions
- 4 Commissioning the "(Flying Saw)"
- 5 Commissioning length-controlled operation
- 6 Commissioning mark-controlled operation
- 7 State machine of the Prepared Solution
- 7.1 Overview
- 7.1.1 Concise description of the states
- "Initialisation" state (g_wState = 100: initialisation)
- "Standby" state (g_wState = 10: standby)
- "Manual operation" state (g_wState = 20: manual mode)
- "Positive inching" state (g_wState = 21: manual jog positive)
- "Negative inching" state (g_wState = 22: manual jog negative)
- "Homing“ state (g_wState = 30: homing operation)
- "Automatic flying saw" state (g_wState = 40: flyingsaw operation)
- "Top cut" state (g_wState = 41: headcut)
- "Length cut" state (g_wState = 42: lengthcut)
- "Mark cut" state (g_wState = 43: TPcut)
- "Move to initial position" state (g_wState = 50: positioning_operation)
- "Trouble" state (g_wState = 1: trouble)
- 7.1.1 Concise description of the states
- 7.2 Parallel functions
- 7.1 Overview
- 8 Program extensions/supplements
- 9 Dimensioning aspects
- 10 Description of the function blocks
- 10.1 Function block MotionControl
- 10.2 Function block Software_Limit
- 10.3 Function block RatioNormFlyingSaw
- 10.4 Function block Master Frequency
- 10.5 Function block LengthCalculation
- 10.6 Function block Offset Calculation
- 10.7 Function block Synchronize Control
- 10.8 Function block VersionHandling
- 10.9 Function block MultiplexerInput
- 10.10 Function block MultiplexerOutput
- 11 Appendix
- Contents