Lenze EVS9332xS - Manual (Page 120)

Function library
Function blocks
3.2.25 Digital frequency output (DFOUT)
3−68
l
EDSVS9332S−EXT EN 2.0
3.2.25.4 Encoder simulation of the resolver
Set C0540 = 2 or C0540 = 3 (depending on the desired generation of the zero track)
l The function is used when a resolver is connected to X7.
l The encoder constant for output X10 is set in C0030.
Generating a zero pulse in resolver zero position (C0540 = 2)
The output of the zero pulse with regard to the rotor depends on how the resolver is mounted to the
motor.
l The zero pulse can be shifted by +360° via C0545 (65536 inc = 360°).
Generating an external zero pulse (C0540 = 3)
An artificial zero pulse can be generated for the output frequency.
l The function is activated through a LOW−HIGH edge at the input DFOUT−SYN−RDY.
l A LOW−HIGH edge at terminal X5/E5 causes the generation of the zero pulse after 360°.
– After this, every 360° a zero pulse is generated according to the setting in C0030.
l The zero pulse can be shifted by +360° via C0545 (65536 inc = 360°).
)
Note!
The procedure for generating an artificial zero pulse must be repeated after every
mains switching and after every setting of C0540 = 3.
3.2.25.5 Direct output of X8 (C0540 = 5)
l The input signal at X8 is electrically amplified and directly output.
l The signals depend on the assignment of the input X8.
l C0030 and C0545 have no function.
l The zero track is only output if it is connected to X8.
3.2.25.6 Direct output of X9 (C0540 = 4)
l The input signal at X9 is electrically amplified and directly output.
l The signals depend on the assignment of the input X9.
l C0030 and C0545 have no function.
l The zero track is only output if it is connected to X9.
)
Note!
For directly outputting X8 or X9 to the digital frequency output X10 the function
block DFOUT does not need to be entered into the processing table.