Wiring inspection – IDEX Health & Science VS-606V7 Series User Manual
Page 27
27
Open the front cover and verify that the strip length is 0.22 in. (5.5mm)
• Wiring Inspection
After completing wiring, check the following:
•
Wiring is properly connected.
•
Wire clippings or screws are not left inside the unit.
•
Screws are securely tightened.
•
Bare wires in the terminal do not come in contact with other terminals.
NOTE
If the FWD (REV) run command is given during the operation reference selec-
tion (n003=1) from the control circuit terminal, the motor will start automatically
after the main circuit input power supply is turned ON.