IDEX Health & Science VS-606V7 Series User Manual
Page 165
165
Notes: 1.
Not initialized by parameter initalization.
2.
Upper limit and initial setting of setting range are doubled at 400 class.
3.
Changes depending on inverter capacity. Refer to the next page.
4.
Changes depending on inverter capacity. Refer to page 64.
5.
Initial setting of the model with operator JVOP-140 (with potentiometer)
is 0. Setting can be set to 1 by parameter initialization.
6.
When control mode selection (n002) is changed, initial setting
correspondents to the control mode.
7.
Changes depend on inverter capacity. Refer to page 101.
8.
Setting value only applies to 200/400V class 7.5/10hp (5.5/7.5kW)
inverters.
9.
Parameter value only applies to 200/400V class 7.5/10hp (5.5/7.5kW)
inverters
10. “1” for 200/400V class 7.5/10hp (5.5/7.5kW) inverters
* Values are double with 400V class.
Initial settings that change with inverter capacity
•
200V class 3-phase
No.
Name
V / f control mode
(n002 = 0)
Vector control mode
(n002 = 1)
n014
Mid. output frequency
1.3Hz
3.0Hz
n015
Mid. output frequency voltage
12.0V*
11.0V*
n016
Minimum output frequency
1.3Hz
1.0Hz
n017
Minimum output frequency voltage
12V*
4.3V*
n104
Torque compensation time parameter
0.3s
0.2s
n111
Slip compensation gain
0.0
1.0
n112
Slip compensation gain time parameter
2.0s
0.2s
No.
Name
Unit
Factory setting
–
Inverter capacity
kW 0.1kW 0.25kW 0.55kW 1.1kW 1.5kW 2.2kW
–
3.7kW 5.5kW 7.5kW
n036 Motor rated current
A
0.6
1.1
1.9
3.3
6.2
8.5
–
14.1
19.6
26.6
n105
Torque
compensation iron
loss
W
1.7
3.4
4.2
6.5
11.1
11.8
–
19
28.8
43.9
n106 Motor rated slip
Hz
2.5
2.6
2.9
2.5
2.6
2.9
–
3.3
1.5
1.3
n107
Motor resistance for
one phase*
Ω
17.99
10.28
4.573
2.575
1.233
0.8
–
0.385
0.199
0.111
n108
Motor leakage
inductance
MH
110.4
56.08
42.21
19.07
13.4
9.81
–
6.34
4.22
2.65
n110
Motor no-load
current
%
72
73
62
55
45
35
–
32
26
30