Using the transfer temp offset option, Print tension settings, Using the ribbon print takeup tension option – HID FARGO HDPii User Guide User Manual

Page 271: Using the film print takeup tension option

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4

271

Using the Transfer Temp Offset Option

This option adds an offset to the temp the printer is reading from the transfer roller. (Note:
This setting should be used only make the temp of the transfer roller and the goal on LCD
match.)
• Use the slider on “Image Transfer” tab to make adjustment for card stock. (Note: A “-”

Adjustment will increase the actual temp of roller.)

Print Tension Settings

Using the Ribbon Print Takeup Tension Option

This procedure controls the tension of the color Ribbon during printing.
• Adjust the Ribbon tension if the Ribbon wrinkle is appearing on the card. (Note:

Adjustments moderately change the image length.)

Using the Film Print Takeup Tension Option

Caution:

The Film Drive sets the baseline for the Film Tension and should not be adjusted

by the reseller or the end User.
• Adjustments moderately change the image length.)