Allied Telesis AT-8202 - Manual (Page 49)

AT-8202 ATM Uplink User’s Guide
2-21
ATM/CONFIG/MODIFY/PTOP Example
This command allows you to modify the configuration parameters of
the PTOP entry using . This command displays the
same screen as the
ATM/CONFIG/CREATE/PTOP
command.
ATM/CONFIG/MODIFY/TRUNK Example
This command allows you to modify the configuration parameters of
the trunking entry using . This command displays
the same screen as the
ATM/CONFIG/CREATE/Trunk
Number> command.
ATM/SHOW Commands
Syntax and (alias)
ATM/SHOW/ARP/CIP (vciparp)
ATM/SHOW/ARP/LEC (vlecarp)
ATM/SHOW/CIP (vcip)
ATM/SHOW/CONNECTION (vac)
ATM/SHOW/LEC (vlec)
ATM/SHOW/PORT (vap)
ATM/SHOW/PTOP (vptop)
ATM/SHOW/TRUNK (vtrunk)
Description
The ATM/SHOW commands allow you to display various ATM states
and settings. See the command examples for a brief description of
each use of the
ATM/SHOW command.
ATM/SHOW/ARP/CIP Example
This command displays the entries in the ARP table of the CIP entity.
The ARP entity contains the resolution of the IP addresses to ATM
addresses at which the destination is accessible. A sample display of
ATM/SHOW/ARP/CIP is shown below, and parameters
are described in Table 2-7.
/ATM/SHOW/ARP >CIP 5
CIP 5 ARP Table Display
IndexIP Address ATM Address VCI Expiry Time
=================================================================================
0
137.168.132.20 0x47000580ffe1000000f215149500204815149500 57 -1 Seconds