Allied Telesis AT-8202 - Manual (Page 20)

Configuring Point-to-Point (PTOP)
1-12
Configuring Point-to-Point (PTOP)
PTOP bridging enables setup between two or more parties to share a
virtual channel connection (VCC) using either a permanent virtual
connection (PVC) or a switched virtual connection (SVC). This feature
supports up to 16 PTOP connections. Only one VLAN and one VCI at a
time can participate in a PTOP configuration.
To configure PTOP parameters for an ATM service, you need to:
❑ Set the PTOP instance ID.
❑ Set the VCI value.
❑ Set the port service for binding an ATM port.
A VLAN with a valid IP address must exist prior to configuring PTOP.
To configure PTOP:
Note
Values shown are for example purposes only; replace with values that
apply to your own configuration.
1. Verify the existence of the VLAN you plan to configure by using
the VLAN/SHOW/VLAN command.
Note
If the VLAN does not exist, create it using the VLAN/CONFIG/VLAN #
command.
2. Create the PTOP services using the ATM/CONFIG/CREATE/
PTOP command.
/VLAN/SHOW > VLAN
Virtual LAN Information:
VLAN VLAN IP Network Admin Operation Port
ID Description Address Status Status Membership
==== =============== ========== ======= ======= ==========
1 Default VLAN(#1 1.1.1.1 ENABLE ACTIVE 1-16