Allied Telesis AT-8202 User Manual
Page 40
ATM/CONFIG/CREATE Commands
2-12
ATM/CONFIG/CREATE/PTOP
This command allows the user to create a PTOP connection, where
of
ATM/CONFIG/CREATE/PTOP
is shown below,
and parameters are described in Table 2-4.
Max. Unknown Frame Count
Maximum number of unknown frames a LEC can send to the broadcast
and unknown server (BUS) for a given unicast LAN destination
Range: 1 – 10
Default: 1
Max. Unknown Frame Time
Works in conjunction with Max. Unknown Frame Count where a LEC
sends no more than the maximum unknown frames within the time
specified
Range: 1 – 60 seconds
Default: 1 second
VCC Time-out
The amount of time a LEC can maintain an unused data direct VCC,
beyond which the LEC must release the VCC
Default: 1200 seconds
Max. Retry Count
Maximum retries for LE ARP entry a LEC can send after the first try
Range: 0 – 2
Ageing Time
The maximum amount of time the LEC can maintain an unverified LE
ARP entry in its cache
Range: 10 – 300 seconds
Expected LE-ARP Resp Time
Maximum amount of time a LEC can expect a response to LE ARP
requests regarding retries and verifications
Range: 1 – 30 seconds
Flush Time-out
Time limit for a LEC to wait to receive a response after sending a flush
request, beyond which the LEC initiates a recovery action
Range: 1 – 4 seconds
Table 2-3 ATM/CONFIG/CREATE/LEC Parameters (Continued)
Parameter
Description