Enter 0 to save the selection, Bind the port service to ptop using the/portser, Use the value of 34 for binding port service to pt – Allied Telesis AT-8202 User Manual
Page 22: Enter 1 as the vlan number to attach to the ser
Configuring Point-to-Point (PTOP)
1-14
VCI values can range from 32 to 1023 (0-31 are reserved by
ATM Forum). A PTOP configuration can accept only one VCI.
5. Enter
0
to save the selection.
6. Bind the port service to PTOP using the
/PORTSERV/CONFIG/
CREATE
command.
Note
Use the value of 34 for binding port service to PTOP for ATM.
7. Enter
1
as the VLAN number to attach to the service.
Enter Selection, 0 to save the Modification or 'q' to Quit:
0
Updating ATM configuration...
/PORTSERV/CONFIG >
CREATE 34
Select ATM Service to bind
1) ATM/LEC
2) ATM/PTOP
3) ATM/TRUNK
Enter an ATM service selection >
2
Select a VLAN to attach the service
Virtual LAN Information:
VLAN
VLAN
IP Network
Admin
Operation
Port
ID
Description
Address
Status
Status
Membership
====
============
==========
======== =======
==========
1
Default VLAN(#1
1.1.1.1
ENABLE
ACTIVE
1-16
Enter a VLAN selection (c to cancel)>
1
PTOP#
VCC
BIND
StatePort Service#
=====
===========
==============
====================
0
502 Bound------
1
1
501 Unbound----
-
Enter a ATM/PTOP selection (c to cancel)>