Allied Telesis AT-8202 - Manual (Page 25)

AT-8202 ATM Uplink User’s Guide
1-17
To create trunking service:
Note
Values shown are for example purposes only; replace with values that
apply to your own configuration.
1. Verify the existence of the VLANs you wish to configure with
trunking by using the VLAN/SHOW/VLAN command.
2. Create the trunking service using the ATM/CONFIG/CREATE/
TRUNK command. Valid trunk index values range from 0 through
15.
/VLAN/SHOW > VLAN
Virtual LAN Information:
VLAN VLAN IP Network Admin Operation Port
ID Description Address Status Status Membership
==== =============== ========== ======= ======= ==========
1 Default VLAN(#1 192.48.127.31 ENABLE ACTIVE 1-8
2 VLAN 2 1.1.1.1 ENABLE ACTIVE 9-16
/ATM/CONFIG/CREATE > trunk 1
TRUNK Configuration
1. TRUNK Index: 1
2. Description (Optional): TRUNK Instance 1
3. Admin Status (ENABLE(a), DISABLE(b)): ENABLED
4. Connection Type (PVC(a), SVC(b)): PVC
5. VCI Value (Reqd if PVC):
6. Destination ATM Address (Reqd if SVC):
Enter Selection, 0 to save the Modification or 'q' to Quit: