Allied Telesis AT-8202 - Manual (Page 18)

Configuring the LAN Emulation Client (LEC)
1-10
The screen displays the following information:
Table 1-4 provides a description of the parameters associated
with binding a port service to a LEC.
4. Enter a number for the ATM service to bind.
/PORTSERV/CONFIG/CREATE 34
Select an ATM Service to bind
1. ATM/LEC
2. ATM/PTOP
3. ATM/TRUNK
Enter an ATM service selection>
Select a VLAN to attach the service
Virtual LAN Information:
VLAN VLAN IP Network Admin Operation Port
ID Description Address Status Status Membership
==== =========== ========== ====== ========= ==========
1 Default VLAN(#1 1.1.1.1 ENABLE ACTIVE 1-16
Table 1-4 Bind Parameters for LEC Configuration
Parameter Description
Select ATM service to bind:
1) ATM/LEC
2) ATM PTOP
3) ATM/TRUNK
Bind LAN emulation client to ATM service.
Bind point to point to ATM service.
Bind trunking service to ATM service.
Enter an ATM Service
selection Indicate ATM service selection
Enter a LEC selection (c to
cancel) Indicate a LEC selection
Port service description (PS
for LEC 1) Port service selection (default)
Port service 1 is created for
physical port 34 Report information only
Port service 1 is bound with
ATMLEC 1 Report information only
Updating system/VLAN
configuration Report information only