Allied Telesis AT-8202 - Manual (Page 14)

Configuring Classical IP Over ATM (CIP)
1-6
3. Enter 2 at the prompt to enable the IP address field:
4. Enter the IP address.
The IP address for this CIP service must exist on a different
connected subnet other than the VLAN on the target switch.
5. Enter the subnet mask.
6. Enter the connection type (PVC or SVC).
Enter A for PVC or B for SVC.
7. Define the VCI value if your Step 6 entry is PVC;
or
Enter the ARP server ATM address if your Step 6 entry is SVC.
8. Keep the default value for MTU size.
9. Set the RIP mode.
10. Enter 0 to save the configuration.
Table 1-2 CIP Configuration Parameters
Parameter Description
CIP Index Index of this CIP entity
IP Address Takes the same IP network number and subnet number of the LIS (logical IP
subnetwork)
IP Subnet Mask Subnet mask for this LIS entity
Description Optional text description of up to 31 characters
Admin Status Administrative status. Options: Enable or disable
Default: Enable
Connection Type Connection type. Options: PVC or SVC
Default: PVC
VCI Value If the connection type is PVC, the virtual channel identifier value for this
connection
Arp Server ATM Address If the connection type is SVC, the ATM address of the ARP server
Mtu Size Maximum transfer unit size for data transfer for this entity
Default is 9180, as defined in RFC 1577, Section 5
RIP Mode Routing internet protocol mode for this CIP entity
Default: Silent
Enter Selection, 0 to save the Modification or ‘q’ to Quit: 2