Allied Telesis AT-8202 - Manual (Page 35)

AT-8202 ATM Uplink User’s Guide
2-7
ATM/CONFIG/CREATE Commands
Syntax and (alias)
ATM/CONFIG/CREATE/CIP (ccip)
ATM/CONFIG/CREATE/LEC (clec)
ATM/CONFIG/CREATE/PTOP (cptop)
ATM/CONFIG/CREATE/TRUNK (ctrunk)
Description
The ATM/CONFIG/CREATE command allow you to configure
available services. See the command examples in this section
for a brief description of these services. Refer also to Chapter 1
for a complete overview of how these services function and
interact.
ATM/CONFIG/CREATE/CIP Example
This command allows you to create a CIP entity, as described in
Chapter 1
, Configuring Classical IP Over ATM (CIP) . If a CIP entity
of that index already exists, the screen displays the error message,
Duplicate Entry .
To connect two switches for CIP service, you must configure the
other switch with a similar configuration. Also, both subnets and VCIs
must be identical on both switches. The CIP index, however, does not
need to be the same on both switches.
A sample display of the command ATM/CONFIG/CREATE/CIP
Index> is shown below. The parameters are described in Table 2-2: