Horner APG XL6 OCS - Manual (Page 64)

CH.12 MAN0883-04-EN
March 4, 2010 Page 64 of 135 #1037
View Status
The View Status Sub-Menu displays up to 17 System Settings. Only the Mode System Setting is
editable.
Model: XL1yz = Model number of this XL6/XL6e OCS unit
1yz indicates the installed I/O module; 00 = no I/O module
OCS Mode:
Idle = XL6/XL6e OCS is in Idle mode
DoIO = XL6/XL6e OCS is in Do I/O mode
Run = XL6/XL6e OCS is in Run mode
Scan Rate(mS):
0.0 = XL6/XL6e OCS is not in Run mode
0.1 to 999.9 = Average number of mS for each ladder scan
OCS Net Use %:
0.0 to 100.0 = CAN network bandwidth % used by this XL6/XL6e OCS node
All Net Use %:
0.0 to 100.0 = CAN network bandwidth % used by all nodes
Ladder Size:
x = Number of bytes in application ladder program
Config Size:
x = Number of bytes in application I/O configuration
Graphics Size:
x = Number of bytes in application graphic screens
String Size:
x = Number of bytes in application string table
Bitmap Size:
x = Number of bytes in application bitmaps
Text Tbl Size:
x = Number of bytes in application text tables
Font Tbl Size:
x = Number of bytes in application font tables
Protocol Size:
x = Number of bytes in application downloaded protocols
SMS File Size:
x = Number of bytes in application SMS protocol configuration
Firmware Rev:
xx.yy = Current firmware version
BIOS Rev:
x.yz = Current CPLD (Complex Programmable Logic Device) version
FPGA Rev:
x.y = Current FPGA (Floating Point Gate Array) version