Horner APG XL6 OCS User Manual
Page 105
MAN0883-05-EN
CH.15
March 4, 2010
Page 105 of 135
#1037
If communications are successful, the target indicator should show the mode of the controller Target:
yy(R) as shown in the status section
in this chapter, section
.
If the controller is not communicating you may need to set the target ID of the controller in Cscape or on
the unit. The Target ID allows directing communications to a particular unit when multiple units are
connected via a CsCAN network. Units without CsCAN network ports respond to any network ID and do
not require the ID to be configured.
To check or change the ID on the XL6/XL6e OCS, press the system menu key.
The first item in the menu is Set Network ID. Pressing Enter allows you to view or modify the ID of the
unit.
To change the Target ID of Cscape use the Controller | Set Target Network ID dialog.
15.3.1 Communicating via MJ1 Serial Port
Start by configuring Cscape to use the correct communications port. This can be done using the
Tools | Options | Communication Port dialog in Cscape.
Next connect the PC’s serial port to the port labeled MJ1 on the XL6/XL6e.
If communications are successful, the target indicator should show the mode of the controller
Target: yy(R) as shown in the status section above.
If the controller is not communicating you may need to set the target ID of the controller in
Cscape or on the unit. The Target ID allows directing communications to a particular unit when