Horner APG XL6 OCS - Manual (Page 45)

MAN0883-05-EN CH.10
March 4, 2010 Page 45 of 135 #1037
Once the back is removed the jumper selection can be changed. The jumper settings are documented on
each data sheet using a diagram such as Figure 9.4 below and a description of the jumper settings.
Figure 10.4 – Example Jumper Diagram
To re-install the cover, place the I/O cover back on the unit.
Place the screw back into the hole and turn the screw slowly counter clockwise until it clicks into the
threads. This prevents the screw from being cross-threaded. Now turn the screw clock-wise until the
cover is firmly secured. Repeat this process for all four (4) screws.
10.3
Model and I/O Overview
Table 10.1 – I/O and Model Overview
Model
(XL6/XL6e)
Solid State
Digital
Outputs
Relay
Outputs
Digital
Inputs Analog
Inputs
Universal
Analog Inputs
Analog
Outputs
HE-XL1x0 /
HEXTxxxC100
HE-XL1E0 /
HEXT351C100
HE-XL1x2 /
HEXTxxxC112
HE-XL1E2 /
HEXT351C112
9 9 9
HE-XL1x3 /
HEXTxxxC113
HE-XL1E3 /
HEXT351C113
9 9 9
HE-XL1x4 /
HEXTxxxC114
HE-XL1E4 /
HEXT351C114
9 9 9
HE-XL1x5 /
HEXTxxxC115
HE-XL1E5 /
HEXT351C115
9 9 9 9
Table 10.1 shows the different types of I/O included with the various XL6/XL6M/XL6e OCS
models. Specific specifications, jumper settings and wiring diagrams can be found on the data
sheets attached at the end of the manual. Descriptions and applications of the different type of
I/O can be found below.
J1 J2
J3
JP3
JP1
001XLE005-R1
J4