Horner APG XL6 OCS - Manual (Page 107)

MAN0883-05-EN CH.15
March 4, 2010 Page 107 of 135 #1037
15.5 Configuration
An overview of configuration:
(1) Start the configuration by selecting the Controller | I/O Configure menu item.
(2) If the XL6/XL6e OCS is connected to the PC press the Auto Config System button to
automatically detect the Base model, I/O and any communication options.
(3) If the XL6/XL6e OCS is not connected press the Config button to the right of the top of the unit.
This allows the base CPU to be selected.
(4) Select either XL6/XL6e OCS Cscan or XL SERIES OCS No Net from the type drop down box.
(5) Once the type of XL6/XL6e OCS is selected, the model # drop down box will provide the
XL6/XL6e OCS model numbers from which to choose from.
(6) Once the XL6/XL6e OCS CPU is selected, press OK to exit the dialog and configure the I/O that
is present in the first slot.
(7) The I/O configure dialog (Specifically the Module Setup tab) provides 4 buttons to configure all of
the I/O. Go through each area of I/O and configure it.
(8) Once done configuring the I/O OK out of configuration dialogs.
Configuring the XL6/XL6e OCS I/O has four main portions that are covered in this chapter. For additional
information on I/O, refer the chapters covering General I/O or High Speed I/O in this manual.
The four areas of I/O configuration are:
- Digital in / HSC
- Digital out / PWM
- Analog in
- Analog out
15.6
Digital Input / HSC Configuration
The following figure illustrates the Digital Input / HSC Configuration dialog.
Figure 15.2 – Digital Input / HSC Configuration Dialog