Horner APG XL6 OCS - Manual (Page 39)

MAN0883-05-EN CH.10
March 4, 2010 Page 39 of 135 #1037
CHAPTER 9: REMOVABLE MEDIA
9.1 Overview
All XL6/XL6M/XL6e OCS models provide a Removable Media slot, labeled Memory Card, which
supports standard Micro SD Flash memory cards. Micro SD cards can be used to save and load
applications, to capture graphics screens and to log data for later retrieval.
Figure 9.1 – Removable Micro SD Memory Card Slot
9.2
Micro SD Cards
When the Micro SD card format was introduced, it was originally called TransFlash. Cards labeled either
Micro SD or TransFlash, with up to 2.0 GB of Flash memory, are compatible with the XL6/XL6e OCS
Memory slot.
The Memory slot is equipped with a “push-in, push-out” connector and a Micro SD card can be safely
inserted into the Memory slot whether the XL6/XL6e OCS power is On or Off.
To install a Micro SD card: Align its 8-pin gold edge connector down, facing the front of the
XL6/XL6e OCS unit as shown in Figure 9.2; then carefully push it all the way into the Memory
slot. Ensure that it clicks into place.
To remove the Micro SD card: Push down on the top of the card gently to release the spring.
The card pops up for removal.
Figure 9.2 – Installing Removable Memory Card