Horner APG XL6 OCS - Manual (Page 17)

MAN0883-05-EN CH.3
March 4, 2010 Page 17 of 135 #1037
CHAPTER 3: MECHANICAL INSTALLATION
Note: Each XL6/XL6e OCS unit is sent with a datasheet in the box. The datasheet is the first
document you need to refer to for model-specific information related to XL6/XL6e OCS models
such as pin-outs, jumper settings, and other key installation information. Visit our website to obtain
datasheets, user documentation, and updates.
3.1 Overview
The mechanical installation greatly affects the operation, safety and appearance of the system.
Information is provided to mechanically install the unit such as cut-out sizes, mounting procedures and
other recommendations for the proper mechanical installation of the unit.
3.2 Mounting
Requirements
3.2.1 Mounting Procedures (Installed in a Panel Door)
Figure 3.1 – Panel Mounting of an XL6/XL6e Series OCS
Once the panel design has been completed using the criteria and suggestions in the
following sections, use the following steps to panel mount the XL6/XL6e OCS.
1. Remove all connectors from the XL6/XL6e OCS unit.
2. Make sure the gasket is installed on the XL6/XL6e OCS and is free from dust and
debris. Check that the corners of the gasket are secure.
3. Pass the unit through the panel.
4. Insert the each of the four (4) mounting clips into the slots in the XL6/XL6e OCS case.
One clip should be installed on each corner. Lightly tignten each screw so the clip is
held in place.
5. Tighten the screws on the clips such that the gasket is compressed against the panel.
001OCS001 001OCS002