Horner APG XL6 OCS - Manual (Page 127)

MAN0883-05-EN CH.19
March 4, 2010 Page 127 of 135 #1037
CHAPTER 19: TROUBLESHOOTING / TECHNICAL SUPPORT
Chapter 18 provides commonly requested troubleshooting information and checklists for the following
topics.
• Connecting to the XL6 OCS controller
• Local controller and local I/O
• CsCAN
Network
• Removable
media
In the event that this information is not what you need, please contact Technical Support at the locations
indicated at the end of this chapter.
19.1
Connecting to the XL6/XL6e OCS
Cscape connects to the local controller automatically when the serial connection is made. The status bar
below shows an example of a successful connection. This status bar is located in the bottom right hand
corner of the Cscape window.
In general the Target number should match the Local number. The exception to this is when the
controller is being used as a "pass through" unit where other controllers on a CsCAN network could be
accessed through the local controller.
Determine connection status by examining feedback next to Local & Target in the status bar of Cscape.
Local: ###
If a number shows next to Local then communication is established to the local controller.
Local: No Port
Cscape is unable to access the COM port of the PC. This could mean that Cscape is
configured for a COM port that is not present or that another program has control of the
COM port. Only one Cscape window can access a port at a time. Subsequent instances of
Cscape opened will indicate No Port.
Local: No Com
Cscape has accessed a PC COM port, but is not communicating with the controller. This
typically occurs when the controller is not physically connected.
Local: ??? Unknown communication error. Close Cscape, power cycle the controller and reopen
Cscape with a blank project. Check Local.
Target: #(I,R,D)
If I (idle), R (run), or D (do I/O) shows next to Target number then communication is
established to the target controller.
Target: #(?)
Communication is not established to the target controller. Check node ID of controller and
set Target to match. Make sure local connection is established.