Vaisala PTU300 - Manual (Page 57)

Chapter 3 ________________________________________________________________ Installation
VAISALA ________________________________________________________________________ 55
Relays
PTU300 can be equipped with one configurable relay module. Each
module contains two configurable relays. See the contact ratings in
section Technical Specifications of Optional Modules on page 187.
Installation and Wiring
1. Disconnect the power and open the transmitter cover. In case the
relay-module is installed in the factory, continue with step 5.
2. To attach the module fasten the relay module to the bottom of the
housing with four screws. See the position in Figure 2 on page 25.
3. When the mains power is in use attach the grounding wire to the
grounding terminal.
4. Connect the flat cable between the relay module and the
MODULE 1 pins of the motherboard.
5. Take out the protective plug from the cable gland and thread the
relay wires.
6. Connect the wires to the screw terminals: NO, C, and NC. Refer to
section Selecting the Activation State of the Relay.
7. Connect the power and close the cover.
Selecting the Activation State of the Relay
The middlemost C terminal and either one of the terminals NO/NC must
be connected. The polarity can be freely selected.
NO Normally open
C
Common relay
NC Normally closed
Relay NOT activated: C and NC outputs are closed, NO is open
Relay IS activated: C and NO outputs are closed, NC is open.
NOTE For instructions on how to operate the relay (for example, selecting
quantity for the relay output and setting the relay setpoints), see section
Operation of Relays on page 132.