Ag Leader PF3000Pro Cotton Yield Monitor Operators Manual - Manual (Page 33)

PF3000 Pro Cotton Yield Monitor
Ag Leader Technology Creating, Naming Fields, & Loads
July 2003 2-19
Recommendations All the information recorded by the PF3000 Pro Cotton Yield Monitor must
be recorded in a field and load. The field and load that the monitor is set on
is located on the top line of the display on the main operating screen.
Fields
You should at least create all the fields and name them before you begin to
use the PF3000. You should choose field names that you can use year after
year.
If you are unable to properly set-up your monitor before harvest, you may
create fields as you harvest. If there are errors made by the operator in that
the fields did not get changed at the proper time or did nor get changed at
all, you may use a sort feature in the SMS software that allows you to
automatically sort the data into the correct field. This is only possible if you
have created boundaries for each of the fields.
Second Pick Option: The second pick feature is available so if you second
pick a field, you can separate the data from the first pick which allows for
further analysis. The second pick feature also allows there to be one
calibration set for all second pick fields and loads.
Loads
It also recommended to create and name loads within fields before you use
the PF3000. Each operating mode of the PF3000 Pro Cotton Yield
Monitor will have its own set of loads for each field.
Definition:
Load: A load is used to subdivide a field into smaller sections. The
monitor load is not associated with the picker basket, wagon, or
truck load.